Corner Mount	Wedge Mount

Overview

The Wired Doorbell 2K+ camera points straight out from the included mount. If the included mount doesn't provide the desired viewing angle, consider two alternative mounts (sold separately) that offer additional adjustment options: 

• Corner Mount: If you need to adjust the horizontal angle, the mount offers a 25° tilt to the left or right. 
• Wedge Mount: If you need to adjust the vertical angle, the mount provides a 5° vertical tilt, allowing you to tilt the camera slightly up or down.

These mounting accessories can help you optimize the camera's field of view for your specific installation location. Choose the appropriate mount based on whether you need to adjust the vertical or horizontal angle of your doorbell camera.

Installing the Corner or Wedge Mount

1. Assemble the mount to create the desired camera angle. Mount the bracket 40–48 inches high on the doorframe, and drill through the slits in the wedge/corner.
   
2. Use the screws and anchors (included in your kit) to secure it. Make sure the wires are accessible through the opening in the bracket.
   
3. Attach and screw the back plate onto the mount. Make sure the wires are accessible through the opening in the bracket.
   
4. Connect the two doorbell wires to the terminals on the back of the Wired Doorbell 2K+. The wires are not polarity-sensitive, either wire can connect to either terminal. If your existing wires are too short to reach the terminals, use extension wires to extend them. 
   
5. Attach and secure your doorbell onto the back plate.
   
6. Switch the power back on. Your doorbell will power up automatically.

Verify the installation

Once the doorbell is installed, test its functionality by pressing the doorbell button and ensuring it operates correctly. Then, open the Blink app to check the camera view and make any necessary adjustments. If desired, fine-tune your doorbell's settings by configuring the Activity and Privacy Zones within the app to customize motion detection and recording areas.